FRP AG T2 Diffuser > Subaru BRZ 2013-2021 - 109358

Disclaimer:

VSAero diffusers are not "direct bolt-on" parts and often require extensive preparation, including sanding, fitting, or custom bodywork. Common issues may arise, such as potential warping, cracking, or fitment challenges if not handled or installed properly.

Typically, VSAero diffusers fit below the rear bumper, and modifications to the bumper may be necessary to accommodate the diffuser. It’s important to note that many diffusers are designed to fit specific bumpers or aftermarket styles, so careful attention to design and compatibility is essential when selecting and installing a diffuser.

In terms of installation, VSAero diffusers typically require separate mounting hardware, which is not included with the product. This hardware may consist of L-brackets, bolts, screws, washers, and other fasteners. L-brackets are often used to securely attach the diffuser to the vehicle's chassis or bumper, while bolts and screws ensure a tight fit. Depending on the design and specific fitment of the diffuser, additional supports or reinforcements may be necessary. Since this hardware is not included, installers will need to source the appropriate materials separately, ensuring compatibility with both the diffuser and the vehicle.

For optimal results, VSAero recommends professional installation by a custom shop experienced with fiberglass components and aftermarket accessories, as traditional auto repair shops may lack the expertise to properly handle the nuances of fiberglass fitment and hardware requirements.

Please note that VSAero diffusers are strictly intended for off-road and show use. Due to Department of Transportation (DOT) regulations, most VSAero diffusers are not street legal. VSAero disclaims any responsibility for damage or injury resulting from the use of these diffusers and does not endorse or recommend their use on public roads or highways.